Line 32: |
Line 32: |
| == Operation == | | == Operation == |
| | | |
− | === [[Prusa i3 OctoPrint Server]] === | + | ===Preparr the Printer=== |
| + | ====''1. Clean the nozzle''==== |
| | | |
− | The Prusa i3 MK2S printer at IP address 10.100.1.203 uses OctoPrint as its host device. Enter that IP address into your web browser, via any computer/device on the PS1 network, to send jobs to the .203 printer.
| + | put info here |
| | | |
− | '''Note:''' the other two i3 3D printers (at 10.100.1.202 and .204) do not use OctoPrint. For those two printers, you must manually load your .STL files on a SD Card on a computer, then load the SD card in one of those printers. | + | ====''2. Load material spool''==== |
| + | put info here |
| + | |
| + | ====''3. Clean the bed''==== |
| + | put info here |
| + | |
| + | ====''4. Set printer settings for your job''==== |
| + | put info here |
| + | |
| + | |
| + | ===Prepare Your .STL file=== |
| + | Put info about Prusa Slicer here... |
| + | |
| + | |
| + | ===Upload & Print Your .STL File=== |
| + | |
| + | ====''The Prusa i3 MK2S printers at IP address 10.100.1.202 and 10.100.1.204''==== |
| + | 1. Load your .STL file onto an SD card (some are provided at PS1). |
| + | 2. Insert SD card into printer. |
| + | 3. Then...[put info here] |
| + | |
| + | ====''The Prusa i3 MK2S printer at IP address 10.100.1.203''==== |
| + | This printer uses the [[Prusa i3 OctoPrint Server]] as its host device. Enter that IP address into your web browser, via any computer/device on the PS1 network, to send jobs to the .203 printer. |
| + | |
| + | ''Connecting to OctoPrint (.203 Printer Only) |
| + | Open a web browser connected to a computer/device on the PS1 network & enter 10.100.1.203 in the IP address field. |
| | | |
| * When connecting to the OctoPrint server, you may first need to select "Connect" under the left side Connection tab if the printer has been turned off. | | * When connecting to the OctoPrint server, you may first need to select "Connect" under the left side Connection tab if the printer has been turned off. |