Changes

Jump to: navigation, search

Form1+ Design Limits

912 bytes added, 10:06, 14 March 2019
Created page with " == Form 1+ Model Design == The Form 1+ design limits are found at FormLabs site [https://formlabs.com/media/upload/formlabs-design-guide.pdf]. Since these are in metric uni..."

== Form 1+ Model Design ==

The Form 1+ design limits are found at FormLabs site [https://formlabs.com/media/upload/formlabs-design-guide.pdf]. Since these are in metric units, this page has been added with the imperial units. These parameters use standard 3D nomenclature.

* Minimum Supported Wall Thickness: 0.4 mm [0.016 in]
* Minimum Unsupported Wall Thickness: 0.6 mm [0.024 in]
* Maximum Unsupported Overhang Length: 1.0 mm [0.039 in]
* Minimum Unsupported Overhang Angle: 19°
* Maximum Horizontal Support Span/Bridge: 21 mm (5 mm width, 3 mm Thick) [0.945 in]
* Minimum Vertical-Wire Diameter: 0.3 mm [0.012 in] @ 7 mm [0.276 in] Tall to 1.5 mm [0.059 in] @ 30 mm [1.181 in] Tall
* Minimum Embossed Detail: 0.1 mm [0.004 in]
* Minimum Engraved Detail: 0.4 mm [0.016 in]
* Minimum Clearance: 0.5 mm [0.020 in]
* Minimum Hole Diameter: 0.5 mm [0.020 in]
* Minimum Drain Hole Diameter: 3.5 mm [0.138 in]
20
edits

Navigation menu