Difference between revisions of "3D Print Troubleshooting"
Jump to navigation
Jump to search
(Created page with "Placeholder, will flesh out later. === Moisture in Filament === === PLA === === ABS === ABS has warping issues and needs to retain heat.") |
|||
Line 1: | Line 1: | ||
− | + | [https://www.simplify3d.com/support/print-quality-troubleshooting/#gaps-between-infill-and-outline Common problems with identifying images.] | |
=== Moisture in Filament === | === Moisture in Filament === | ||
+ | Our filament mostly isn't stored in an airtight container. This means that the filament will absorb water over time. Hydrolysis is when a water molecule breaks a plastic polymer chain. The water can also vaporize and create air bubbles and voids. This affects print quality in every aspect: | ||
+ | # Loss of strength | ||
+ | # Poor finish | ||
+ | # Poor adhesion between layers | ||
+ | # Poor adhesion to the bed. | ||
+ | # Failed prints. | ||
=== PLA === | === PLA === |
Revision as of 23:31, 17 October 2018
Common problems with identifying images.
Moisture in Filament
Our filament mostly isn't stored in an airtight container. This means that the filament will absorb water over time. Hydrolysis is when a water molecule breaks a plastic polymer chain. The water can also vaporize and create air bubbles and voids. This affects print quality in every aspect:
# Loss of strength # Poor finish # Poor adhesion between layers # Poor adhesion to the bed. # Failed prints.
PLA
ABS
ABS has warping issues and needs to retain heat.