Boss Laser Settings

From Pumping Station: One Wiki
Revision as of 16:31, 30 September 2017 by Mct (talk | contribs) (add link to boss)
Jump to: navigation, search

The below is to help you figure out your settings for your cutting job on the Boss Laser. Please do not be creative with settings unless you know what you're doing, because you can easily set things on fire.

Test Cuts

There are several test cut pieces. These test various power/speed in a pie shape going from 10% to 100%. These are a good starting point.

Known Settings

Known, successfully used settings.


Material Thickness Speed (mm/second) Power (%)
Plywood 1/4" 25? 80
ABS 1/8" 20 65
Cermark Engraving Brass 30 70
Masonite 1/8" 15 50


Material Depth Speed (mm/second) Power (%)
Masonite 0.4mm 100 10
Masonite 1mm 100 15
Masonite 1.3mm 100 20
Masonite 1.6mm 100 25