1,238
edits
Changes
Jump to navigation
Jump to search
Line 109:
Line 109: − + − + − + + + + + + + + + + + + +
→Starting a job from a particular line of code (needs update)
# Click Cycle Start (green).
# Click Cycle Start (green).
=== Starting a job from a particular line of code (needs update)===
=== Starting a job from a particular line of code ===
*Run from here
*Double click on the code preview window to see the line number that mach3 assigns to the line. (mach3#:sheetcam# - example 11:N110)
*Select next line
*Be careful and be ready to hit the e-stop
*If you don't know the exact line to start from, find the line directly after a TCH off before the line the job stopped. If it errors on that line try moving to the next movement line. The job should do some air moves until the next probe.
*Type the number of the line in the area "Line:_____" right next to the red stop button.
*Type Enter. The gcode preview should jump to the line you typed in.
*Click the "Set next line" button.
*Click the green Cycle Start button.
=== The job stopped while probing (not z-crash or skipping steps) ===
*Record the g-code line where the machine stopped.
*Check to see if there are any errors. If there errors send a message to Slack about them.
*Be careful and be ready to hit the e-stop.
*Click "Reset" twice (the first time goes into estop mode and the second time comes out of it).
*Click "Cycle Start". The cnc should move to pierce height and then start cutting (generally running correctly again)
=== Previewing a job (needs update) ===
=== Previewing a job (needs update) ===