Line 8: |
Line 8: |
| |image = Sense 3d Scanner.jpeg | | |image = Sense 3d Scanner.jpeg |
| |doesitwork = yes | | |doesitwork = yes |
− | |contact = Will Garza, Ray Doeksen | + | |contact = [[CNC|CNC Area Host]], or Will Garza, or Ray Doeksen |
| |where = On top of CubePro Trio 3D printer | | |where = On top of CubePro Trio 3D printer |
| |value = $400 | | |value = $400 |
| + | |hostarea = CNC |
| }} | | }} |
− | == Getting Started == | + | |
− | # Download the sense software to your laptop (PC/Mac): http://cubify.com/en/Products/SenseActivate | + | The 3Dsystems account is registered to the info@ email and the password can be found in the ticketing system. |
| + | |
| + | == Getting Started with Sense Software == |
| + | # Download the sense software to your laptop (PC/Mac) - link below |
| # Install the software | | # Install the software |
− | # When prompted input 7205 as registration code | + | # When prompted input registration code (taped to the side of the scanner) |
| + | # Plug in the scanner into a USB port |
| + | # Let Windows install the drivers - when complete Device Manager should show a USB Device > PrimeSense > PrimeSense Carmine 1.09 |
| # Follow on screen instructions to begin scanning | | # Follow on screen instructions to begin scanning |
| | | |
| + | ==Software== |
| + | ===Sense 3D Scanner (native)=== |
| + | * https://www.3dsystems.com/shop/support/sense/downloads |
| + | * SenseSetup_v2.2 |
| + | * Seems to work well, simple interface |
| + | |
| + | ===ReconstructMe=== |
| + | * http://reconstructme.net/ |
| + | * ReconstructMe_64bit_2.5.1034 |
| + | * Go into settings and select the Carmine Scanner |
| + | * Somewhat slow |
| + | |
| + | ===Skanect=== |
| + | * https://skanect.occipital.com/download/ |
| + | * Skanect-1.9.1-win64.exe |
| + | * Recording wasn't starting without a little bit of start delay |
| + | * Fast with lots of options |
| | | |
− | * The sense software is also installed on the computer to the right of the cube pro, but is impractical to use from an immobile desktop tower
| |
| | | |
| [[File:Sense 3d Scanner location.jpeg|left|thumb|Sense 3d Scanner Location]] | | [[File:Sense 3d Scanner location.jpeg|left|thumb|Sense 3d Scanner Location]] |
| + | |
| + | ==Troubleshooting== |
| + | * The scanner doesn't light up or tell you that it's on - except for a small internal red LED. |
| + | * The right and left side snap on and can pop off if you need to get inside. |
| + | * The cable feels loose but strain relief is internal to the device. |
| | | |
| == Documentation == | | == Documentation == |