Cubify Sense 3d Scanner
From Pumping Station One
Revision as of 23:59, 4 November 2018 by Rtystgeeke (talk | contribs)
 | |
| Owner/Loaner | PS:One |
|---|---|
| Serial Number | 1405210468 |
| Make/Model | Sense |
| Arrival Date | 2014 |
| Usability | yes |
| Contact | CNC Area Host, or Will Garza, or Ray Doeksen |
| Where | On top of CubePro Trio 3D printer |
| Authorization Needed | no |
| Hackable | no |
| Estimated Value | $400 |
| Host Area | CNC |
The 3Dsystems account is registered to the info@ email and the password can be found in the ticketing system.
Getting Started with Sense Software
- Download the sense software to your laptop (PC/Mac) - link below
- Install the software
- When prompted input registration code (taped to the side of the scanner)
- Plug in the scanner into a USB port
- Let Windows install the drivers - when complete Device Manager should show a USB Device > PrimeSense > PrimeSense Carmine 1.09
- Follow on screen instructions to begin scanning
Software
Sense 3D Scanner (native)
- https://www.3dsystems.com/shop/support/sense/downloads
- SenseSetup_v2.2
- Seems to work well, simple interface
ReconstructMe
- http://reconstructme.net/
- ReconstructMe_64bit_2.5.1034
- Go into settings and select the Carmine Scanner
- Somewhat slow
Skanect
- https://skanect.occipital.com/download/
- Skanect-1.9.1-win64.exe
- Recording wasn't starting without a little bit of start delay
- Fast with lots of options
Troubleshooting
- The scanner doesn't light up or tell you that it's on - except for a small internal red LED.
- The right and left side snap on and can pop off if you need to get inside.
- The cable feels loose but strain relief is internal to the device.
