Difference between revisions of "DoAll Bandsaw"
Jump to navigation
Jump to search
| Line 65: | Line 65: | ||
|- | |- | ||
|Gear Box | |Gear Box | ||
| − | | | + | | |
| | | | ||
| | | | ||
| Line 71: | Line 71: | ||
| | | | ||
|- | |- | ||
| − | | | + | |Reeves drive shaft (oil cup) |
| | | | ||
| | | | ||
Revision as of 16:14, 27 September 2014
 | This tool is currently broken, please contact the area host for more information. |
| Owner/Loaner | PS:One |
|---|---|
| Make/Model | DoAll 16-2 |
| Arrival Date | 9/19/14 |
| Usability | soon |
| Contact | Dean Anderson |
| Authorization Needed | yes |
| Hackable | no |
| Estimated Value | 900 |
| Host Area | {{{hostarea}}} |
This tool requires certification for use.
Specifications
| Capacity | 16" from the blade to the column |
| Blade Size | 120" blade. Width can be up to 1". Each blade width requires a set of four hardened steel guides. We don't have guides for blades wider than 1/2". |
| Blade Speed | approximately 45 to 1600 FPM, continuously variable. |
| Power | 240V, 3 phase |
| Weight | 1500-2000 pounds |
| Mfg. Date | 1955 |
Blades
Installed:
To-Do
Install new blade.
Change oil in transmission.
Replace thrust bearings in blade guide.
Blade welder is missing the grinder motor. The welder has not been tested. The 20 amp plug/outlet may not be sufficient.
Maintenance
| Description | Frequency | Lubricant | Instructions | History |
|---|---|---|---|---|
| Gear Box | ||||
| Reeves drive shaft (oil cup) |
Equipment
| Item | Description | Supplier | Cost |
|---|---|---|---|
References
List of Currently Certified Users
| Qualified Member | Trained By |
|---|---|
| Dean Anderson | |