DoAll Bandsaw

DoAll Bandsaw
Owner/Loaner	PS:One
Serial Number	45-55525
Make/Model	DoAll 16-2
Arrival Date	9/19/14
Usability	yes
Contact	Dean Anderson
Where	machine shop
Authorization Needed	yes
Hackable	no
Estimated Value	900
Host Area	{{{hostarea}}}

This tool requires certification for use.

Specifications

Capacity	16" from the blade to the column
Blade Size	120" blade. Width can be up to 1". Each blade width requires a set of four hardened steel guides. We don't have guides for blades wider than 1/2".
Blade Speed	approximately 45 to 1600 FPM, continuously variable.
Power	240V, 3 phase
Weight	1500-2000 pounds
Mfg. Date	1955

Operating Notes

Change speed range by moving the lever up and to the other side. Only do this when the motor is running and when the variable speed setting is at its lowest speed.

Change the variable speed setting only when the motor is running.

Blades

Installed:

To-Do

Install new blade.

Replace thrust bearings in blade guide.

Blade welder is missing the grinder motor. The welder has not been tested. The 20 amp plug/outlet may not be sufficient.

Maintenance

Description	Lubricant	Instructions	History

Gear Box	The manual for model 16-2 (our saw) says to use SAE 10 motor oil. The manual for the 1612 (a slightly newer model) says SAE 20. DoAll support says use SAE 20 motor oil, which is difficult to find. ISO 68 waylube is equivalent to SAE 20 and available from Zengers in Melrose Park.	The drain plug is at the bottom of the gear box. Remove pipe cap and fill to the top of the pipe. Takes about 1 quart.	Changed 10/7/14 with ISO 68. Only about 2 cups of oil were drained, but no sign of a leak.
Reeves drive shaft (oil cup)	1612: SAE 10

Equipment

Item	Description	Supplier	Cost
Guide thrust bearing	626ZZ 6x19x6mm (2 required)

References

List of Currently Certified Users

Qualified Member	Trained By
Dean Anderson
Everett Wilson	Dean Anderson
Ed Bennett	Dean Anderson