Difference between revisions of "Evenheat 810 Kiln"
Jump to navigation
Jump to search
| Line 1: | Line 1: | ||
| − | {{Template:EquipmentPage |owner=PS:One |model=Evenheat 810 |serial=38008 |arrived=2010 |doesitwork=Yes |contact=Eric Stein |where= | + | {{Template:EquipmentPage |owner=PS:One |model=Evenheat 810 |serial=38008 |arrived=2010 |doesitwork=Yes |contact=Eric Stein |where=[[:Category:Arts|Arts - Graphic Arts and Textiles]] |certification=yes |hackable=no |value=$865 |hostarea=craft}}<br /> |
== History == | == History == | ||
Revision as of 18:57, 2 January 2017
| Owner/Loaner | PS:One |
|---|---|
| Serial Number | 38008 |
| Make/Model | Evenheat 810 |
| Arrival Date | 2010 |
| Usability | Yes |
| Contact | Eric Stein |
| Where | Arts - Graphic Arts and Textiles |
| Authorization Needed | yes |
| Hackable | no |
| Estimated Value | $865 |
| Host Area | craft |
History
On 1/28/2013 this was tested to at least power up and create heat.
3/3/2014. Inspect and test all mechanical and electrical components.
Remove upper switch, disassemble, clean contacts, reassemble and reinstall.
All components appear to works as intended.
Heating Profile
On 3/3/2014 I ran the kiln using a PID temperature controller set to 2200f.
Room temp to 500f. 7 min.
Room temp to 1000f. 17 min.
Room temp to 1500f. 40 min.
Room temp to 2000f. 95 min.