Appeared to be fully functional as of 15 Sept 2018.
+
Eric fixed the broken cutter <UNSAFE to use until fixed, 1/18/2019
+
At least one broken indexable cutter. >
−
October 16 2018. Several bad gouges/chips in blades. signs of severe misuse. Please check your materials for nails etc. Repaired but just barely.
+
October 16 2018. Several bad gouges/chips in blades. signs of severe misuse. Please check your materials for nails etc. Repaired but just barely.
+
3/30/2019 The outfeed surface is out of alignment with the infeed surface, causing the work to teeter over the blades halfway down and making an uneven surface on the work (a gouge at the fulcrum point). REALIGNED..
−
== jan 2 2019 Blade guard totally loose needs spring repair BE CAREFUL ==
+
July 2019...We have purchased a new 12 inch Jointer. Will assemble a Danger committee to devise training once it is connected to Dust Collection and power ....approx October). This is part of the Dust Collection / Shop reorganization sequence.
+
+
== Jan 2 2019 Blade guard totally loose needs spring repair BE CAREFUL ==