Domain Admins
586
edits
Changes
Jump to navigation
Jump to search
Line 28:
Line 28: + + + + + + + + + +
Mitsui Surface Grinder (view source)
Revision as of 11:32, 18 February 2017
, 11:32, 18 February 2017no edit summary
# A mag chuck will need to be ground in.
# A mag chuck will need to be ground in.
# Five block test can be used as a quick diagnosis.
# Five block test can be used as a quick diagnosis.
== Table Removal ==
The table needs to be removed periodically to clean the grinding grit from the ways.
The table is heavy. We need a system for lifting the table off of the saddle. THe engine hoist doesn't work well. Perhaps a ceiling supported crane would work.
# Remove the nut at the end of the cable on the right side under the table. Fasten a weight to the end of the cable to prevent the cable from unwinding on the capstan.
== Moving the grinder ==
The ball ways need to be removed anytime the grinder is moved. This is necessary to prevent the races from Brinelling. To remove the ball ways, disconnect the X axis cable at each end of the table then prop up the ends of the table.