Difference between revisions of "Prusa i3 OctoPrint Server"
Jump to navigation
Jump to search
Line 16: | Line 16: | ||
== IP Address == | == IP Address == | ||
− | http://10.100.1.202/ | + | http://10.100.1.202/ is the left Prusa as of December 4, 2018 |
− | http://10.100.1.203/ | + | http://10.100.1.203/ is the "middle" Prusa as of December 4, 2018, and has a broken SD card reader. You must use Octoprint to print. |
− | + | The Prusa on the top shelf is not yet provided with an Octoprint server, but you may still use SD cards to print. | |
== Current Status == | == Current Status == |
Revision as of 20:03, 4 December 2018
Owner/Loaner | PS:One |
---|---|
Serial Number | N/A |
Make/Model | Raspberry Pi 3 |
Arrival Date | April 2017 |
Usability | yes |
Contact | CNC Area Host |
Where | CNC 1st Floor |
Authorization Needed | yes |
Hackable | no |
Estimated Value | $50 |
Host Area | CNC |
IP Address
http://10.100.1.202/ is the left Prusa as of December 4, 2018
http://10.100.1.203/ is the "middle" Prusa as of December 4, 2018, and has a broken SD card reader. You must use Octoprint to print.
The Prusa on the top shelf is not yet provided with an Octoprint server, but you may still use SD cards to print.
Current Status
Offline.
Authorization
Authorization for this device is determined by authorization for the Prusa i3 3D printer.
Operation
Please see Prusa i3 3D printer#Prusa i3 OctoPrint Server
Recommended Non-Stock Plugins
- Slicer (1.2.5)
- A full-blown GUI-based slicer. Rotate and scale model; set layer height and other critical parameters.