Difference between revisions of "Rockwell drill press"

From Pumping Station: One Wiki
Jump to: navigation, search
(List of Currently Authorized Users)
(Auth/Use Notes)
Line 33: Line 33:
 
These notes are for reference after authorization by a person.
 
These notes are for reference after authorization by a person.
  
Only use drills and accessories with correct shank taper and tang
+
The spindle switch must be 'off' and the e-stop (big red button) must be in the out position (twist the button counter clockwise) before the spindle can be turned on.
 
 
Be sure the e-stop (big red button) is in the out position by twisting the button counter clockwise.  This must be done before turning on the power, otherwise the spindle will not operate.
 
  
 
Authorizations from the old DoAll drill press carry over to this machine.
 
Authorizations from the old DoAll drill press carry over to this machine.

Revision as of 00:13, 27 March 2017


Rockwell drill press
Owner/Loaner PS:One
Serial Number 1456658
Make/Model Rockwell 17-600 17" Drill Press
Arrival Date December 2016
Usability yes
Contact Dean Anderson
Where Cold Metals
Authorization Needed yes
Hackable no
Estimated Value $500
Host Area {{{hostarea}}}


Rockwell drill press Area: {{{hostarea}}} https://wiki.pumpingstationone.org/Rockwell_drill_press




Specifications

17" capacity (from the center of the spindle to the column).

VFD controlled 3 phase motor. Continuously variable spindle speed from 250-??.

Morse #2 taper spindle

Capacity, mild steel 1/2"

Drills to center 17"

approximate weight ?? pounds

motor HP 1


Auth/Use Notes

These notes are for reference after authorization by a person.

The spindle switch must be 'off' and the e-stop (big red button) must be in the out position (twist the button counter clockwise) before the spindle can be turned on.

Authorizations from the old DoAll drill press carry over to this machine.

The motor direction is reversible using a switch on the back of the control box. For nearly all drills, the spindle must rotate clockwise when viewed from above.

Setup material securely on the table. Turn e-stop counter clockwise Turn on power switch on the back of the control box Set the RPM based on the material being drilled and the drill diameter. Set the direction switch on the back of the control box to 'forward'. Move the spindle switch to 'on' when you are ready to drill. To turn off, push the e-stop or flip the spindle switch.

To-Do

Maintenance

Equipment

References

List of Currently Authorized Users

Qualified Member Trained By Date Trained
Dean Anderson
Everett Wilson Dean Anderson
Bruce Mace Chris Ruhland 3/7/17
Brian Adamson Chris Ruhland 3/23/2017