Sherline 8 inch lathe + milling column
Jump to navigation
Jump to search
larval tool page blather
Ralph Brendler very generously donated this "full Sherline clockmaking (metric) setup with all the trimmings (rotating table, change gears, milling column, and lots more)". Apparently in 2017. Time passed. Per area host Jim Brink, Paul is "danger committee of one" checking it out and trying to get it online. This is a start at documenting the tool and determining what authorization it may or may not require. Eventually this blathery part will go away.
Inventory
Component | Sherline SKU | Instructions | Note (from memory...) |
---|---|---|---|
8” Lathe with Adjustable Handwheels (Metric) | 4530 | looks complete; morse #1 rusty | |
Lathe Deluxe Vertical Milling Column - Manual (Metric) | 3485 | complete | |
2.5” 3-Jaw Chuck (3/4-16 thread) | 1041 | complete. on turntable. | |
Headstock Riser Block Set | 1291 | missing alignment key | |
Clockmaker’s Gear-cutting Arbor (7.0mm to #1 Morse taper) | 2094 | missing drawbolt (bolt is trivial but washer is special) | |
Cutters | |||
Crosslide Accessory Plate | 3017 | stiffen crosslide for milling | |
Slitting Saw Holder | 3065 | missing drawbolt (bolt is trivial but washer is special) | |
Slitting Saw[s] [which?] | 730x | ||
End Mill Holder (3/8") | 3079 | ||
Thread Cutting Attachment | 3100 | complete; amazing; zillion parts | |
Mill Vise | 3551 | ||
Manual Rotary Table | 3700 | ||
Right Angle Attachment (for rotary table) | 3701 | complete | |
1/4" Drill Chuck with 2 Arbors | 1072 | conjectural - because have #0 arbor & 1/4in chuck key; if so, missing chuck, #1 arbor and drawbolt | |
more | some Sherline-special T-nuts missing; only need one drawbolt+washer but have zero |