Difference between revisions of "Shop Fox 8" Plate Shear"

From Pumping Station: One Wiki
Jump to: navigation, search
Line 4: Line 4:
 
| doesitwork = yes
 
| doesitwork = yes
 
| contact = Michael Skilton
 
| contact = Michael Skilton
| where = Cold Metals
+
| where =  
 
| certification = No
 
| certification = No
 
| hackable = No
 
| hackable = No
Line 32: Line 32:
 
[[Category:Fabrication]]
 
[[Category:Fabrication]]
 
[[Category:Cold Metals]]
 
[[Category:Cold Metals]]
[[Category:Loaned Equipment]]
+
[[Category:Retired Equipment]]

Revision as of 16:48, 13 March 2020


Shop Fox 8" Plate Shear
Shop Fox plate shear.jpg
Owner/Loaner Michael Skilton
Serial Number {{{serial}}}
Make/Model M1040
Arrival Date 2013
Usability yes
Contact Michael Skilton
Authorization Needed No
Hackable No
Estimated Value $100
Host Area {{{hostarea}}}


Shop Fox 8" Plate Shear Michael Skilton Area: {{{hostarea}}} https://wiki.pumpingstationone.org/Shop_Fox_8%22_Plate_Shear



Removed by owner 3/13/20

Note

Primarily designed for straight cuts in sheet metal.

Nothing harder then mild steel.

The knurled knob is meant to be a clamp and is helpful for thicker materials.

Flat stock only on the blades, No channel or angle etc.

No rod or wire except in the hole.

It will cut 1/8 mild steel and 1/2" rod but I recommend 12 gauge sheet and 3/8 diameter as maximums.

Pull slowly and be prepared for a jolt if you are pulling hard at the end of a cut.