Difference between revisions of "Shop Fox 8" Plate Shear"
Jump to navigation
Jump to search
Line 4: | Line 4: | ||
| doesitwork = yes | | doesitwork = yes | ||
| contact = Michael Skilton | | contact = Michael Skilton | ||
− | | where = | + | | where = |
| certification = No | | certification = No | ||
| hackable = No | | hackable = No | ||
Line 32: | Line 32: | ||
[[Category:Fabrication]] | [[Category:Fabrication]] | ||
[[Category:Cold Metals]] | [[Category:Cold Metals]] | ||
− | [[Category: | + | [[Category:Retired Equipment]] |
Revision as of 21:48, 13 March 2020
Removed by owner 3/13/20
Note
Primarily designed for straight cuts in sheet metal.
Nothing harder then mild steel.
The knurled knob is meant to be a clamp and is helpful for thicker materials.
Flat stock only on the blades, No channel or angle etc.
No rod or wire except in the hole.
It will cut 1/8 mild steel and 1/2" rod but I recommend 12 gauge sheet and 3/8 diameter as maximums.
Pull slowly and be prepared for a jolt if you are pulling hard at the end of a cut.