577
edits
Changes
Jump to navigation
Jump to search
Line 398:
Line 398: + + + + +
→Maintenance Log
|Updated ShopBot software
|Updated ShopBot software
|Did upgrade from 3.8.14 to 3.8.26. Installed latest firmware on ShopBot controller. (This was mandatory.) Two features of interest: Fixed occasional erractic behavior after repeated Stops and Resumes (and Nudges or Command Insertions). Reduced liklihood of Keypad lockup.
|Did upgrade from 3.8.14 to 3.8.26. Installed latest firmware on ShopBot controller. (This was mandatory.) Two features of interest: Fixed occasional erractic behavior after repeated Stops and Resumes (and Nudges or Command Insertions). Reduced liklihood of Keypad lockup.
|-
|5/31/2015
|Ron Olson
|Created new VCarve Post Processors
|For drag/engraving bits, it's important that the spindle be turned 'off' so as to not destroy the bit. Instead of manually modifying the sbp every time to remove the check that the spindle is turned on, I created a couple of new post processors (inches and mm, similar to Ryan's), that explicitly ''turn off'' the spindle. The user is given two opportunities to cancel the job if that is not what he/she wants.
|-
|-
|}
|}