128
edits
Changes
Jump to navigation
Jump to search
Line 19:
Line 19: + +
→Status history
=Status history=
=Status history=
June 2017: There is an intermittent break in the wiring for the Z-axis Zero Plate. Check for continuity before using (the #1 input should light up on screen when you touch the contacts together). It usually works near the front of the table, but not halfway back. This will get fixed eventually, but it's a good idea to be in the habit of checking.
12/27/16 - Fixed Shopbot x-axis homing. The cable had been pulled on hard enough that some of the conductors broke inside the cable. It has been spliced, soldered, and heatshrinked back together.
12/27/16 - Fixed Shopbot x-axis homing. The cable had been pulled on hard enough that some of the conductors broke inside the cable. It has been spliced, soldered, and heatshrinked back together.