Supermax 25x2 Drum Sander

Supermax 25x2 Drum Sander

Owner/Loaner	PS:One
Serial Number	?
Make/Model	25x2
Usability	yes
Contact	Eric Beauchamp
Where	Wood Shop
Authorization Needed	yes
Hackable	no
Estimated Value	$2700
Host Area	Wood Shop

Notes

• For oily or dense woods (tropical hardwoods, etc), take only very light passes to prevent clogging the sandpaper.

• Use a belt cleaner occasionally to refresh the sandpaper

Safety

This sander features overload detection. If the machine detects too high a load, it will automatically slow down the feed. This saves wear and tear on the machine, but may cause burning of the workpiece if you cut too aggressively.

• The height adjustment on this machine is VERY aggressive. A full turn will raise the table by more than 2mm (a typical cut should be < .5mm). PLEASE USE A MAXIMUM OF 1/8 TURN OF THE HEIGHT WHEEL PER PASS!

• Make your first cuts with a very slow speed (10 or less). Once you are sure the load is OK you can gradually increase the speed on subsequent passes.

• When overload detection kicks in, a red light next to the speed control will turn on. IF YOU SEE THIS LIGHT, PLEASE REDUCE YOUR DEPTH OF CUT AND/OR FEED RATE!

• Like all of our other sanders, sleeves must be above the elbow, and no gloves should be worn. It's pretty easy to get pulled into the rollers.

List of Currently Authorized Users

Qualified Member	Trained By	Date
Eric Beauchamp	Danger committee	6/23/2017
Ralph Brendler	Danger committee	6/23/2017
Paul van Lake	Danger committee	6/23/2017
Zack Sasnow	Jason Shanfield	8/27/17
Justin Pestka	Ralph Brendler	8.30.17
Jacob Snyder	Ralph Brendler	9/7/17
James Beck	Ralph Brendler	9/13/17

Outside Links

• Manufacturer's Page
• Owner's Manual