133
edits
Changes
Jump to navigation
Jump to search
Line 51:
Line 51: − − === Maintenance === − [https://wiki.pumpingstationone.org/Universal_Maintenance Universal Maintenance] − * [[Media:2_Table_Calibration_Platform_Lasers.pdf]] − * [[Media:5_Cleaning_and_Maintenance.pdf]] Line 74:
Line 69: + + Line 79:
Line 76: − + − + − + + − + Line 137:
Line 135: + + + + + + + +
Universal PLS6.150D 150W Laser Engraver (view source)
Revision as of 17:30, 11 February 2020
, 17:30, 11 February 2020no edit summary
== Procedures ==
== Procedures ==
=== Setting Up Your Computer===
=== Setting Up Your Computer===
=== Exhaust ===
=== Exhaust ===
* Turn on the Exhaust Fan by flipping the switch on the gray box to the left of the Boss Laser.
* Turn on the Exhaust Fan by flipping the switch on the gray box to the left of the Boss Laser.
* Make sure the BLAST GATE is open.
* It is always good practice to open the Make-up Air Window to allow fresh air to circulate while running a job.
=== Powering On Machine ===
=== Powering On Machine ===
== Running your job ==
== Running your job ==
*Use the printer driver and Universal Control Panel (UCP) to send data to the laser.
* Use the printer driver and Universal Control Panel (UCP) to send data to the laser.
*The printer driver is discussed from page 39-57 of the manual, and on page 58-62, the UCP is explained.
* The printer driver is discussed from page 39-57 of the manual, and on page 58-62, the UCP is explained.
*https://wiki.pumpingstationone.org/images/Universal_PLS6.150D_user_guide.pdf
* https://wiki.pumpingstationone.org/images/Universal_PLS6.150D_user_guide.pdf
* ALLOW AT LEAST 30 SECONDS TO ELAPSE BEFORE LIFTING THE LID AFTER A JOB.
=== Powering Off Machine ===
=== Powering Off Machine ===
* Allow the Exhaust & Air Assist to run for approximately 10-15 after completing a job. (DO NOT CYCLE THE EXHAUST SYSTEM RAPIDLY).
* Allow the Exhaust & Air Assist to run for approximately 10-15 min. after completing a job. (DO NOT CYCLE THE EXHAUST SYSTEM RAPIDLY).
* Turn off the Exhaust & Air Assist FIRST
* Turn off the Exhaust & Air Assist FIRST
* Power down the machine
* Power down the machine
|}
|}
== Maintenance ==
Please note that ONLY authorized maintainers are allowed to perform regular maintenance.
[https://wiki.pumpingstationone.org/Universal_Maintenance Universal Maintenance]
* [[Media:2_Table_Calibration_Platform_Lasers.pdf]]
* [[Media:5_Cleaning_and_Maintenance.pdf]]
== List of Currently Authorized Users ==
== List of Currently Authorized Users ==