225
edits
Changes
Jump to navigation
Jump to search
Line 62:
Line 62: + +
Universal PLS6.150D 150W Laser Engraver (view source)
Revision as of 02:31, 13 July 2018
, 02:31, 13 July 2018no edit summary
* Check the WATER TRAP adjacent to the regulator for accumulated water from time to time. Place a container (and maybe some paper towels) under the regulator and vent accumulated water from the bottom using the small petcock. If too much water accumulates in the regulator, it may flow through the air hose and into the machine, spraying onto the bed/material.
* Check the WATER TRAP adjacent to the regulator for accumulated water from time to time. Place a container (and maybe some paper towels) under the regulator and vent accumulated water from the bottom using the small petcock. If too much water accumulates in the regulator, it may flow through the air hose and into the machine, spraying onto the bed/material.
=== Exhaust ===
* Turn on the Exhaust Fan by flipping the switch on the gray box to the left of the Boss Laser.
=== Powering On Machine ===
=== Powering On Machine ===
* Turn on the Power Switch and let the machine complete the entire boot up cycle, approximately 1-2 minutes.
* Turn on the Power Switch and let the machine complete the entire boot up cycle, approximately 1-2 minutes.