User:Andrewvaughan/SNES-in-a-Controller
< User:Andrewvaughan
Jump to navigation
Jump to search
Revision as of 22:11, 26 April 2017 by Andrewvaughan (talk | contribs)
This project is currently in development and should not be currently considered complete. Contact the project owner for more information. |
Creator | Andrew Vaughan |
---|---|
Version | 1.0 |
Date | April 26, 2017 |
Estimated Time | 30 Minutes |
Estimated Cost | $33-$43 |
With the size of gaming devices and development boards becoming smaller and smaller, it was only a matter of time before someone put a console inside the controller. Using a Raspberry Pi Zero, a standard USB SNES Controller, and a few extra parts, you can make yourself a portable, rechargeable gaming emulator self-contained in its own controller.
What You'll Need
Parts
Part | Cost |
---|---|
Raspberry Pi Zero (or Raspberry Pi Zero W) | $10 |
USB SNES Controller | $6.90 |
MicroHDMI to HDMI Adapter | $1.40 |
2500mAH 3.7v Lithium Ion Polymer Battery with 2-Pin JST-PH Connector | $14.95 |
500mA Power Boost Circuit | $9.95 |
MicroUSB Power Cable, HDMI Cable, and Television/Monitor | N/A |
Total | $43.20 |
Tools
TK
Steps
TK
Tips
- Whenever using Lithium Ion Polymer batteries, pay close attention to maximum charge rates and amperages. Even with protection circuits in-place, these should always be treated with care.
- Remember that most Lithium Ion Polymer batteries do not have thermal protection circuitry built in.
- To reduce cost, an original Raspberry Pi Zero can be used, but note that, due to lack of network connectivity (the USB data ports are fully in-use), all administration of the platform (including game uploading) must be done on a separate system
- To further reduce cost, the size of the battery can be reduced to 1200mAH, or less - but playtime will be drastically reduced between charges.