Difference between revisions of "Wood Shop Dust Collection Design Notes"
Line 1: | Line 1: | ||
Design Guidelines for Clearview Dust Collector | Design Guidelines for Clearview Dust Collector | ||
+ | |||
+ | Install the collector in the pallet rack behind the Shopbot. This will make the mounting of the motor easy and provide a framework for a sound enclosure, if it is necessary. The approximate dimensions of the rack are 44" wide x 33" deep x 9' tall. | ||
Inlet port on dust collector is angled up at 11 degrees. | Inlet port on dust collector is angled up at 11 degrees. |
Revision as of 23:47, 4 June 2014
Design Guidelines for Clearview Dust Collector
Install the collector in the pallet rack behind the Shopbot. This will make the mounting of the motor easy and provide a framework for a sound enclosure, if it is necessary. The approximate dimensions of the rack are 44" wide x 33" deep x 9' tall.
Inlet port on dust collector is angled up at 11 degrees.
To reduce turbulence in the collector, first 5 feet should be straight with no fittings.
Put down drop blast gates as close to the main duct as possible.
Use SRD-35 or ASTN D3034 PVC or 24 gauge spiral duct or thicker.
Two 45 degree elbows has lower resistance than a single 90. Putting a short piece of straight pipe between the 45s is best.
3 phase motor is 99 pounds.
Use at least 5" port on machines for best results.
Clearvue blast gates are sized for PVC pipe.
Clearvue order:
CVMAX 3 phase with filters with nano filter upgrade $1870+100
filter clean out box $80
quantity:6 6" blast gates $15 each
DC1100 Pro Air Quality Monitor with PC interface $289.99
Discount code for 5% off: CVCFAN