Difference between revisions of "Wood Shop Dust Collection Design Notes"
| Line 44: | Line 44: | ||
Discount code for 5% off: CVCFAN | Discount code for 5% off: CVCFAN | ||
| + | |||
| + | Estimated delivery: June 18. | ||
Revision as of 17:48, 10 June 2014
Collector Mounting
Install the collector in the pallet rack behind the Shopbot. This will make the mounting of the motor easy and provide a framework for a sound enclosure, if necessary. The collector motor will be mounted on top of a piece of 3/4 plywood that is secured to the top shelf of the rack.
The approximate dimensions of the rack are 44" wide x 33" deep x 8.5' tall. Dimensions of the collector without the inlet tube are approximately 24"x34"x8'. (is this also true for the nano filter?)
Inlet port on dust collector is angled up at 11 degrees.
3 phase motor is 99 pounds.
Ducting
To reduce turbulence in the collector, first 5 feet should be straight with no fittings.
Put down drop blast gates as close to the main duct as possible.
Use SRD-35 or ASTN D3034 PVC or 24 gauge spiral duct or thicker.
Two 45 degree elbows has lower resistance than a single 90. Putting a short piece of straight pipe between the 45s is best.
Use at least 5" port on machines for best results.
Clearvue blast gates are sized for PVC pipe.
Links
Installation of a CVMAX that includes VFD, sound proofing, muffler. http://mastslav.weebly.com/
Clearvue order
CVMAX 3 phase with filters with nano filter upgrade $1870+100
filter clean out box $80
quantity:6 6" blast gates $15 each
DC1100 Pro Air Quality Monitor with PC interface $289.99
Discount code for 5% off: CVCFAN
Estimated delivery: June 18.