Difference between revisions of "Wood Shop Dust Collection Design Notes"

From Pumping Station One
Jump to navigation Jump to search
(Created page with "Design Guidelines for Clearview Dust Collector Inlet port on dust collector is angled up at 11 degrees. To reduce turbulence in the collector, first 5 feet should be strai...")
(No difference)

Revision as of 07:57, 4 June 2014

Design Guidelines for Clearview Dust Collector

Inlet port on dust collector is angled up at 11 degrees.

To reduce turbulence in the collector, first 5 feet should be straight with no fittings.

Put down drop blast gates as close to the main duct as possible.

Use SRD-35 or ASTN D3034 PVC or 24 gauge spiral duct or thicker.

Two 45 degree elbows has lower resistance than a single 90. Putting a short piece of straight pipe between the 45s is best.

3 phase motor is 99 pounds.

Use at least 5" port on machines for best results.

Clearvue blast gates are sized for PVC pipe.

Clearvue order:

CVMAX 3 phase

nano filter

filter box

6 6" blast gates

particle monitor