Line 10: |
Line 10: |
| | | |
| == Getting an Access Code == | | == Getting an Access Code == |
− | In order to get the access code, you should A: be a paying member in good standing with the organization, and B: have your [[Bylaws#Eligibility | id checked]] by 2 board members. The best time to get your | + | In order to get the access code, you should A: be a paying member in good standing with the organization, and B: have your [[Bylaws#Eligibility|id checked]] by 2 board members. The best time to get your ID checked is at a general meeting which occur every Tuesday at 8:00pm. |
| | | |
| == Reprogramming the Lock == | | == Reprogramming the Lock == |
| | | |
| The full manual is available at http://www.alarmlock.com/images/pdf/ETPDL_PDL3X00_WI1021C.07_PROG.pdf | | The full manual is available at http://www.alarmlock.com/images/pdf/ETPDL_PDL3X00_WI1021C.07_PROG.pdf |
| + | |
| + | * The document may not render the keypad font correctly, making the document useless. |
| + | ** It fails to render correctly in firefox, and OS X's preview application. |
| + | ** It renders correctly in [https://get.adobe.com/reader/ Adobe Reader] for OS X. |
| + | ** It renders correctly in Chrome. |
| + | |
| + | == Sharing the door code == |
| + | |
| + | * Please don't share the door code with non-members |
| + | * If you don't have the ability to verify membership status, please don't give out the door code. |
| + | |
| + | == Changing the door code == |
| + | |
| + | Door code logic: each allowed code is associated with a user id between the numbers 12 and 50, inclusive. |
| + | |
| + | The door codes are documented on a ''User Code Record Sheet'' that is stored in the safe. |
| + | |
| + | === Programming the door === |
| + | |
| + | To program the door, enter programming mode and enter function codes. All function codes take the form <code>A {function code} (A params) *</code>. While programming mode is enabled, the door will beep every few seconds. You may enter functions until you exit programming mode. To Exit Programming mode, hold down any button for 3 seconds. |
| + | |
| + | |
| + | <code>{MASTER CODE} A</code> |
| + | |
| + | You are now in program mode until you hold a button for 3 seconds. |
| + | |
| + | ==== Adding ==== |
| + | |
| + | <code>A 2 A {User ID} A {CODE} *</code> |
| + | |
| + | ==== Deleting ==== |
| + | |
| + | <code>A 2 A {USER ID} *</code> |
| + | |
| + | ==== Temporarily Unlocking ==== |
| + | |
| + | <code>A 47 A {HOURS} *</code> |
| + | |
| + | == Erasing All Programing == |
| + | |
| + | # Remove battery |
| + | # Hold down A for 10 seconds (drain the capaciters) |
| + | # Reinstall Battery |
| + | # withing 5 seconds of hearing 3 beeps, Hold A until it beeps more |
| + | # The lock is now reset, the master programming code is now the default. |