Difference between revisions of "Jet Wood Lathe"
Jump to navigation
Jump to search
Line 68: | Line 68: | ||
{| class="wikitable" border="1" | {| class="wikitable" border="1" | ||
! Qualified Member | ! Qualified Member | ||
− | ! | + | ! Authorized By |
|- | |- | ||
|Matt Triano | |Matt Triano | ||
Line 81: | Line 81: | ||
|Michael Skilton | |Michael Skilton | ||
|Danger Committee | |Danger Committee | ||
+ | |- | ||
+ | |} | ||
+ | == Authorized Users== | ||
+ | {| class="wikitable" border="1" | ||
+ | ! Qualified Member | ||
+ | ! Authorized By | ||
|- | |- | ||
|} | |} |
Revision as of 13:46, 26 October 2014
Jet Wood Lathe
Owner/Loaner | Joeseph Nudell |
---|---|
Serial Number | NAN |
Make/Model | Jet 1236 |
Arrival Date | 6/1/14 |
Usability | yes |
Contact | Joeseph Nudell |
Where | Woodshop |
Authorization Needed | yes |
Hackable | no |
Estimated Value | 800 |
Host Area | {{{hostarea}}} |
This tool requires authorization for use.
Authorization is by authorized proctors only
PERSONAL PROTECTIVE EQUIPMENT
- Face shield or safety glasses must be worn.
- Long and loose hair must be contained.
- Do not wear gloves or loose clothing.
- Remove watches,rings,and other jewelry.
- Don't wear long sleeves or roll them up.
- Hearing protection may be required.
- Dust protection may be required.
PRE-OPERATIONAL SAFETY CHECKS
- Locate and ensure you are familiar with all machine operations and controls.
- Ensure all guards are fitted, secure and functional. Do not operate if guards are missing or faulty.
- Workpiece must be securely fastened to face plate, chuck or between centers.
- Adjust speed to suit the diameter of the work and turning operation.
- Rotate the workpiece by hand to check clearance between tool rest and bed.
- Ensure the cutting tools are sharp and in good condition.
- Start the dust extraction unit before using the machine.
- Make sure all clamping handles are tight,
OPERATIONAL SAFETY CHECKS
- Before making adjustments, switch off and bring the machine to a complete standstill.
- Keep the tool rest adjusted close to the work and at the correct height.
- Adjust speed to suit the diameter of the work and turning operation.
- Stop the lathe and remove all tool rests before sanding.
ENDING OPERATIONS AND CLEANING UP
- Switch off the machine when work completed.
- Return all chisels and other tools to racks.
- Leave the machine in a safe, clean and tidy state.
POTENTIAL HAZARDS AND INJURIES
- Eye injuries from flying debris or defective timber.
- Hair/clothing getting caught in moving machine parts.
- Airborne dust.
DO
- Rough cut the workpiece as close as possible to the finished shape before installing it.
- Check your workpiece for flaws, cracks, knots etc.and test glue joints before mounting the workpiece on machine.
- Use the lowest speed when starting a new workpiece.
- Remove the tool rest before sanding or polishing.
DON'T
- Drive the workpiece into the drive center while the drive center is in the headstock.
- Set the drive center into the workpiece with a soft mallet prior to installing it on the headstock.
Authorized Proctors
Qualified Member | Authorized By |
---|---|
Matt Triano | Danger Committee |
Joeseph Nudell | Danger Committee |
Jason Shanfield | Danger Committee |
Michael Skilton | Danger Committee |
Authorized Users
Qualified Member | Authorized By |
---|
Documentation
https://wiki.pumpingstationone.org/Wood_Lathe_Authorization_Checklist