Difference between revisions of "Vacuum table"
Jump to navigation
Jump to search
(Created page with "{{Template:EquipmentPage |owner = Khoi Nguyen |certification=yes |hackable = NO |model = |serial = |arrived = Dec 2014 |doesitwork = yes |contact = Khoi Nguyen |where = Wood...") |
|||
Line 3: | Line 3: | ||
|certification=yes | |certification=yes | ||
|hackable = NO | |hackable = NO | ||
− | |model = | + | |model = N/A |
− | |serial = | + | |serial = N/A |
|arrived = Dec 2014 | |arrived = Dec 2014 | ||
|doesitwork = yes | |doesitwork = yes | ||
|contact = Khoi Nguyen | |contact = Khoi Nguyen | ||
|where = Woodshop Under Worktable | |where = Woodshop Under Worktable | ||
− | |value = $ | + | |value = $500.00 |
|image = VacuumTable.jpg | |image = VacuumTable.jpg | ||
}} | }} | ||
+ | |||
+ | == General == | ||
+ | |||
+ | This is a | ||
+ | |||
== Rules == | == Rules == | ||
− | # Use for Large flat objects, | + | # Use for Large flat objects or small delicate objects, '''Not''' for glueing dimensional lumber |
− | # ALWAYS Check | + | #* If clamps can be used to achieve your goal, please use them instead |
+ | # '''ALWAYS''' Check for sharp edges on your work pieces, as they can puncture (read: ruin) the bag | ||
+ | #*use the extra piece of plastic over any work piece that you are gluing or has sharp corners | ||
+ | #*it is best to sand or otherwise smooth all corners of your work piece as well | ||
+ | #Check to make sure that the vacuum has stabilized at 21 before you leave your work unattended for curing time | ||
+ | #*if the vaccum does not turn off after 10-15 minutes of run time there may be a leak | ||
+ | |||
− | |||
− | |||
− | |||
== List of Currently Certified Users == | == List of Currently Certified Users == |
Revision as of 17:31, 17 December 2014
General
This is a
Rules
- Use for Large flat objects or small delicate objects, Not for glueing dimensional lumber
- If clamps can be used to achieve your goal, please use them instead
- ALWAYS Check for sharp edges on your work pieces, as they can puncture (read: ruin) the bag
- use the extra piece of plastic over any work piece that you are gluing or has sharp corners
- it is best to sand or otherwise smooth all corners of your work piece as well
- Check to make sure that the vacuum has stabilized at 21 before you leave your work unattended for curing time
- if the vaccum does not turn off after 10-15 minutes of run time there may be a leak
List of Currently Certified Users
Qualified Member | Trained By |
---|---|
Khoi Nguyen | Owner |
Will Garza | Khoi Nguyen |