718
edits
Changes
From Pumping Station One
Peristaltic pump controller (view source)
Revision as of 16:52, 16 August 2017
, 16:52, 16 August 2017no edit summary
{{Template:EquipmentPage
{{Template:EquipmentPage
|owner = Ryan Pierce
|owner = Ryan Pierce
|serial = Unknown
|serial = Unknown
|arrived = November, 2012
|arrived = November, 2012
|doesitwork = WORKING, but Eric Stein broke the screw on the front (yell at him and make him fix it). The needed part is a 1 3/4" 6/32 machine screw to replace to broken screw-on shank.
|doesitwork = yes
|contact = Ryan Pierce
|contact = Ryan Pierce
|where = [[Beer Church]]
|where = [[Beer Church]]
|value = $140
|value = $140
}}
}}
== Operation ==
TODO: write up properly. For now, just hints:
Make sure to screw on the retainer clamp... but not too tight. It's only there to prevent the tubing from walking in the housing, which can cause it to get eaten up. Do'nt clamp it so hard it leaves marks. When you're done using the pump remove the tubing shortly thereafter, leaving it clamped can dent the tubing permanently.
== Accessories ==
* [http://www.amazon.com/gp/product/B000FOWH7U/ref=oh_details_o00_s00_i00 Translucent Tygon Tygoprene Tubing, 1/4" ID, 3/8" OD, 1/16" Wall, 10' Length] is the tubing used with this device.
== List of Currently Certified Users ==
== List of Currently Certified Users ==
|Ryan Pierce
|Ryan Pierce
|}
|}
[[Category:Brewing]]
[[Category:Photographs Needed]]
[[Category:Loaned Equipment]]
