I found a couple more problems when testing all the limits. When I took the gantry to X maximum, the dust collector hose pulled off! I put it back on, but I'm not sure how stable this is. Also, when I originally set the Y maximum and minimum, I wanted as much spindle travel as possible. But it appears that if you're at the Y max and move in the X direction, you can hit the middle support with the dust collector boot. We've got several inches Y travel beyond the nominal 48", so we may want to look into reducing this to clear the supports. | I found a couple more problems when testing all the limits. When I took the gantry to X maximum, the dust collector hose pulled off! I put it back on, but I'm not sure how stable this is. Also, when I originally set the Y maximum and minimum, I wanted as much spindle travel as possible. But it appears that if you're at the Y max and move in the X direction, you can hit the middle support with the dust collector boot. We've got several inches Y travel beyond the nominal 48", so we may want to look into reducing this to clear the supports. |