Difference between revisions of "Tormach 1300PL CNC Plasma Cutter"
Jump to navigation
Jump to search
Tachoknight (talk | contribs) (→Status) |
Tachoknight (talk | contribs) |
||
Line 15: | Line 15: | ||
== Description == | == Description == | ||
Will fill this in later. | Will fill this in later. | ||
+ | |||
+ | == Maintenance == | ||
+ | (Shamelessly copied from page 58 in the manual) | ||
+ | === Daily === | ||
+ | * Clean the machine of any dust or abrasive particle buildup with a vacuum and brushes. | ||
+ | * Wipe dust off of the linear rails with a clean cloth. | ||
+ | === Weekly === | ||
+ | * Clean all exterior surfaces with a mild cleaner. | ||
+ | * Examine the water table's level and, if necessary, add water / rust inhibitor (GreenCut). | ||
+ | * Check your plasma torch consumables for wear and replace if needed. | ||
+ | === Monthly === | ||
+ | * Clean the electrical cabinet vents of dust with a clean cloth or compressed air. | ||
+ | * Remove the slats and clean sediment buildup from the bottom of the water table. | ||
+ | === Semi-Annually === | ||
+ | * Check drive belts for wear and re-tension if needed. | ||
+ | * Remove faceplate from torch lifter and clean lead screw with a lint-free cloth. | ||
== Status == | == Status == |
Revision as of 16:39, 3 January 2023
Description
Will fill this in later.
Maintenance
(Shamelessly copied from page 58 in the manual)
Daily
- Clean the machine of any dust or abrasive particle buildup with a vacuum and brushes.
- Wipe dust off of the linear rails with a clean cloth.
Weekly
- Clean all exterior surfaces with a mild cleaner.
- Examine the water table's level and, if necessary, add water / rust inhibitor (GreenCut).
- Check your plasma torch consumables for wear and replace if needed.
Monthly
- Clean the electrical cabinet vents of dust with a clean cloth or compressed air.
- Remove the slats and clean sediment buildup from the bottom of the water table.
Semi-Annually
- Check drive belts for wear and re-tension if needed.
- Remove faceplate from torch lifter and clean lead screw with a lint-free cloth.
Status
1/3/23: Working great, getting ready for authorizations
12/9/22: Waiting on power for the plasma torch.