Tormach 1300PL CNC Plasma Cutter
Description
Will fill this in later.
Maintenance
(Shamelessly copied from page 58 in the manual)
Daily
- Clean the machine of any dust or abrasive particle buildup with a vacuum and brushes.
- Wipe dust off of the linear rails with a clean cloth.
Weekly
- Clean all exterior surfaces with a mild cleaner.
- Examine the water table's level and, if necessary, add water / rust inhibitor (GreenCut).
- Check your plasma torch consumables for wear and replace if needed.
Monthly
- Clean the electrical cabinet vents of dust with a clean cloth or compressed air.
- Remove the slats and clean sediment buildup from the bottom of the water table.
Semi-Annually
- Check drive belts for wear and re-tension if needed.
- Remove faceplate from torch lifter and clean lead screw with a lint-free cloth.
Status
1/3/23: Working great, getting ready for authorizations
12/9/22: Waiting on power for the plasma torch.