1,524
edits
Changes
Jump to navigation
Jump to search
Line 35:
Line 35: + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + +
→Maintenance
[[Category:CNC]]
[[Category:CNC]]
CubePro Filament Flow Error
Check the cartridge - Is the filament releasing freely from the cartridge without binding up. If it is jammed, open the cartridge using the thumb tabs on the side of the unit and try to untangle the filament. If this is unsuccessful we will be happy to replace the cartridge to resolve the issue.
If the cartridge is not jammed, move forward with checking the print jet
Check the print jet - Go to the control jets function on the touch screen to test the print jet. Choose the corresponding print jet by selecting A, B, or C. Set the temperature to 260C. Once the actual temperature meets 260C, turn the RPM up to 4.0. This will start the gears which should make the machine start extruding material. Follow steps below depending on what happens.
Filament Flow Error - No material extruding - no clicking noise present - It is possible that the material is not properly loaded and the gears are not catching the filament. Please follow the link below for steps on reloading the filament.
https://teamplatform.com/l/c88cec3e
Filament Flow Error - No material extruding - clicking noise present - The clicking noise is consistent with a clogged print jet. Please follow the below instructions for removing the clog.
1. Go to the control jets function on the touch screen
2. Set the temperature to 290C.
3. Once the actual temperature meets 290C, turn the RPMs to 1.0
4. Run for several minutes (If the filament flow error comes up, continue to steps for manually removing clog)
5. Set the temperature back to 0C
6. Go to the change cartridge function and load the filament
7. Go back to the control jets function to test the print jet.
If the above steps do not resolve the issue, follow the link below for instructions on manually removing the clog.
https://www.dropbox.com/s/e40gfn7m1al9fti/CubeProJamTroubleshootingGuide.pdf?dl=0
If manually removing the clog does not resolve the issue a new print jet assembly will be needed.
No Filament Error Present - Material is extruding correctly - This confirms that the print jet is functioning correctly. The error message received during the print is related to settings. If the Z gap is to tight and the plate is not level, the material has nowhere to go and will throw a filament flow error. Please refer to the user guide for setting the Z gap and leveling the print Pad.