Line 6: |
Line 6: |
| ==CNC Area== | | ==CNC Area== |
| *Crimp cables and metal tags/labels to all calipers | | *Crimp cables and metal tags/labels to all calipers |
| + | *Clean and lubricate the Shopbot guide rails |
| + | *Clean and lubricate CNC Plasma cutter rails |
| + | *Stiffen CNC plasma cutter |
| + | *Add z probe to CNC plasma cutter |
| | | |
| ==Electronics Area== | | ==Electronics Area== |
| + | *Clean whiteboard paint wall |
| + | *Hang large sheets of showerboard to the CNC wall |
| | | |
| ==Arts Area== | | ==Arts Area== |
Line 13: |
Line 19: |
| ==Hot Metals Area== | | ==Hot Metals Area== |
| *Exhaust gas ventilation to outside for plasma cutter and welders. | | *Exhaust gas ventilation to outside for plasma cutter and welders. |
| + | *Sweep! |
| | | |
| ==Cold Metals Area== | | ==Cold Metals Area== |
− | *Emerson/Sears mini band saw
| |
− | **Replace motor and pulley
| |
− | **Fix switch
| |
− | **Setup for cutting thing metal / tube stock etc
| |
| | | |
| ==Wood Shop Area== | | ==Wood Shop Area== |
− | *Add dust collection drop for new planer. May need to order elbows, 6" blast gate, 6" flanges. | + | *Add dust collection inlets for unconnected machines |
− | *Add floor sweep inlet for the dust collector | + | *Build manifold to small duct collector for sanding station |
− | | + | *Build Chopsaw table. |
− | ==Tool Cage Area==
| + | *Add floor sweep inlet for the dust collector. |
| | | |
| ==Kitchen Area== | | ==Kitchen Area== |
− | *Add sliding door to kitchen (check fire codes)
| |
| *Seal gap between catwalk and wall. | | *Seal gap between catwalk and wall. |
| + | *Mop the floor |