293
edits
Changes
From Pumping Station One
mLine 3:
Line 3: + + + + + + + + Line 11:
Line 19: + + + + +
→Changing/Replacing BOSS Tube
== Cleaning Lens ==
== Cleaning Lens ==
You can only mess this up in three ways:
# Scratching the lens
# Leaving a fingerprint on the lens surface (hold by the edge).
# Not screwing things back in properly.
Avoid those three things and you're good, I promise. It's not hard, a 9 year old could do this.
To clean the lens:
# Unscrew the laser head/nozzle. It's pretty easy to figure out.
# Unscrew the laser head/nozzle. It's pretty easy to figure out.
# The lens is held in place by an internal threaded "tube" (insert better word here) that can be removed by unscrewing with a key. It's almost like a standard slotted screw head, except hollow in the middle. The key is the exact width of the hole so it'll touch the sides of the slotted, threaded tube. (This sounds incomprehensible, but if you just look inside it's obvious how it works).
# The lens is held in place by an internal threaded "tube" (insert better word here) that can be removed by unscrewing with a key. It's almost like a standard slotted screw head, except hollow in the middle. The key is the exact width of the hole so it'll touch the sides of the slotted, threaded tube. (This sounds incomprehensible, but if you just look inside it's obvious how it works).
# Screw the threaded slotted tube back in.
# Screw the threaded slotted tube back in.
# Screw back in the laser nozzle.
# Screw back in the laser nozzle.
== Changing/Replacing BOSS Tube ==
1. Purchasing a 150W tube
2. Grounding
