131
edits
Changes
Jump to navigation
Jump to search
Line 12:
Line 12: − + − + − # Turn on the toggle switch by the laser computer to turn on the air assist. − # Double check #1 and #2 - not having the cooler, air exhaust or air assist on could be damaging and ruin everyone's day. Line 73:
Line 71: + + + +
no edit summary
==Preparation to Use==
==Preparation to Use==
===Turn On Safety/Heat Dissipating Systems===
===Turn On Safety/Heat Dissipating Systems===
# Turn on the two switches by the air exhaust exiting the ceiling of the CNC room. One is for air exhaust, and the other is for the cooler. Both need to be on.
# Turn on the the rocker switch by the Boss computer. It turns on the air assist, the water cooler, and the exhaust fan.
#* Do NOT touch the cooler switch. Instead you're turning on the "lightswitch" behind the cooler. The cooler itself always stays on.
#* Do NOT touch the cooler switch by the exhaust pipe. The cooler itself always stays on.
===Turn On The Laser===
===Turn On The Laser===
# Click the "Output?" button on the laser computer. It's near the bottom right of the screen.
# Click the "Output?" button on the laser computer. It's near the bottom right of the screen.
# Immediately watch from the edge of the lid to see it cutting. You didn't start a fire, did you - you pyromanic, you...
# Immediately watch from the edge of the lid to see it cutting. You didn't start a fire, did you - you pyromanic, you...
====Troubleshooting====
A "Frame Slop" error means your job is going to try cutting outside the X/Y the boss can do. You probably need to move your origin away from the edge.
==Finishing Up==
==Finishing Up==