Line 11: |
Line 11: |
| |contact = [[User:Rtystgeeke]] | | |contact = [[User:Rtystgeeke]] |
| |value = tbd | | |value = tbd |
− | |image = | + | |image = [[File:Belovac Vacuum Former Main.jpg|300px]] |
| }} | | }} |
| | | |
Line 38: |
Line 38: |
| ===Usage Steps=== | | ===Usage Steps=== |
| | | |
− | 1. Insert Material into Frame
| + | The following instructions are an initial release of how to run the machine. |
− | 2. Secure Mold to Vacuum table
| + | |
− | 3. Check seals aronud material and mold
| + | # Insert sheet of material into Frame |
− | 4. Turn on Wall Power
| + | # Secure Mold to Vacuum table |
− | 5. Turn on Machine Power
| + | # Check seals around material and mold |
− | 6. Select Number of Heating Elements
| + | # Turn on Wall Power |
− | 7. Select Duty Cycle
| + | # Turn on Machine Power |
− | 8. Connect Pnuematic Hose
| + | # Select Number of Heating Elements |
− | 9. Turn on Heating Element
| + | # Select Duty Cycle |
− | 10. Move material frame into heater
| + | # Connect Pneumatic Hose. It can be borrowed from the CNC Plasma Cutter, if not in use. |
− | 11. Close Vacuum Valve
| + | # Turn on Heating Element |
− | 12. Turn on Vacuum Pump
| + | # Move material frame into heater |
− | 13. Visually check if material is sagging and ready
| + | # Close Vacuum Valve |
− | 14. Pull Material frame forward
| + | # Turn on Vacuum Pump |
− | 15. Inspect Plastic is ready
| + | # Visually check if material is sagging and ready |
− | 16. push level to raise vacuum bed
| + | # Pull Material frame forward |
− | 17. Open Vacuum Valve
| + | # Inspect Plastic is ready |
− | 18. Monitor pull of material over mold
| + | # push level to raise vacuum bed |
− | 19. Turn off Vacuum
| + | # Open Vacuum Valve |
− | 20. Turn off Heater
| + | # Monitor pull of material over mold |
| + | # Turn off Vacuum |
| + | # Turn off Heater |
| | | |
| ===Safety notes=== | | ===Safety notes=== |
Line 68: |
Line 70: |
| | | |
| | | |
− | ===Warning=== | + | ===Warnings=== |
| + | |
| + | * Hot Surface - Metal Frame holding material and handles will be hot. |
| | | |
− | Fire - Heat | + | * Fire - Material may catch fire if left unattended while lower heater is left on. |
| | | |
− | Shock - 3 Phase Power
| + | * Crushing - Maker certain all appendages are clear, before raising pnuematic platform with mold. |
| | | |
− | Crushing - Pnuematic Platform
| + | * Shock - High Voltage machinery (3 Phase Power) required to run motors and heating elements. Make certain cabling is secure. |
| | | |
| ===Maintenance and Repairs=== | | ===Maintenance and Repairs=== |