577
edits
Changes
From Pumping Station One
→Media
[[Category:Shop Equipment]]
[[Category:Shop Equipment]]
[[Category:Fabrication]]
[[Category:Fabrication]]
<span style="color:red">'''''Here because of the stickers on the cabinet regarding changing the media? Read the Media section below!'''''</span>
== Information ==
== Information ==
The cabinet is located behind the curtain near the Temporary Project Area. It acts as a barrier for welding station: two
The cabinet is located behind the curtain near the Temporary Project Area. It acts as a barrier for welding station: two
== Interior Dimensions ==
58" wide, 28" deep, 34-1/2" high
== Media ==
== Media ==
These are the types of media available to use:
* Soda (Very fine)
* Pulverized glass (medium)
* Walnut shells (rough)
* Aluminum Oxide (really rough)
'''''Do not change the media without prior approval from the Hot Metal Shop host!'''''
If you are authorized to use the cabinet, you may change the media to fit your needs. The procedure is as follows:
=== Media changing procedures ===
<span style="color:red">'''''Warning! Remove watches or jewelry you don't want to get scratched up! Also, absolutely wear a respirator to avoid breathing in any of the media!'''''</span>
# Check the sticker on the front of the cabinet to see what media is loaded. If it's not what you need, proceed to step 2.
# Make sure the bucket labeled with the same media as what's in the cabinet is empty, clean and dry.
# Place the bucket under the hopper at the bottom of the cabinet.
# Pull down on the door, it's on a heavy spring and will snap back, you have to hold it. The media will fall into the bucket.
# Make sure the cabinet is free as possible of the old media, mixing and matching media is a no-no.
# Remove the bucket from under the cabinet. ''It will be quite heavy.''
# Put the lid on the bucket!
# Find the bucket of media you want to use, open doors to the cabinet and pour the contents into the cabinet via the grate.
# '''''Label what media is currently loaded, the date, and who loaded it.'''''
# Check the floor and clean up any spilled media. This stuff can be ''very'' slippery, and the person most likely to fall will be you.
# Enjoy!
== Use ==
== Use ==
* Use a respirator while handling media or cleaning vacuum filter.
* Use a respirator while handling media or cleaning vacuum filter.
* Do not point gun at gloves. Use screen tray for parts too small to safely hold.
* Do not point gun at gloves. Use screen tray for parts too small to safely hold.
'''''SERIOUSLY, DO NOT POINT THE GUN AT THE GLASS!'''''
== Tips-n-Tricks ==
* If the gun does not seem to be performing well, try pressing it right against a piece of cardboard and blowing it until the media can be seen coming from the grill near the front of the machine; this clears the line
* Depending on the thickness of the material you're trying to remove, you're potentially in for a long time; grab a stool to sit or lean against and take breaks as bending over can really hurt the back after awhile
== Gun Setup, Parts, and Troubleshooting ==
== Gun Setup, Parts, and Troubleshooting ==
The '''Blasting Cabinet''' bin on the bottom shelf contains new interior glass (really rolled plastic), new gloves, and gun tips
[[Media:Skat blast info.pdf]]
[[Media:Skat blast info.pdf]]
