* POWER UP: If no GPS module installed or GPS bad signal, then
* POWER UP: If no GPS module installed or GPS bad signal, then
** If RTC install & set, then get time from RTC
** If RTC install & set, then get time from RTC
−
*** If no RTC installed, then unable to timestamp (serious error condition?)
+
*** If no RTC installed, then:
−
*** If RTC installed but not set, then prompt for manual time set (how?)
+
**** Obtain timestamp from connected (USB or bluetooth) computing device (smartphone or PC)
+
**** If no computing device connected, then prompt for manual input (how?)
+
+
== Time set by connected computing device ==
+
+
* Shawn mentioned that one simple method would be to set the time on the Arduino based on the serial link (bluetooth or USB) to computing device (smartphone or PC)