Changes

|serial = n/a

|serial = n/a

|arrived = 2017-09-25

|arrived = 2017-09-25

|where = [[Large Mill Accessories Cabinet]]

|where = [[Bridgeport Knee Mill#In the Large Mill Accessories Cabinet|Large Mill Accessories Cabinet]]

|doesitwork = yes

|doesitwork = yes

|contact = [[User:mct|McTavish McArdle]]

|contact = [[User:mct|McTavish McArdle]]

To enable future modification, the 3/8" square shank in the crank adapter is retained in the adapter body with a 1/4" x 1" dowel pin: the square shank is machined onto the end of a short section of 5/8" OD steel rod, which fits loosely (but closely) within the 5/8" ID shaft through the center of the crank. By machining a similar such feature onto the end of a similar section of rod, drilling an appropriate cross hole, & replacing the square shank, any number of drive mechanisms could be supported.

To enable future modification, the 3/8" square shank in the crank adapter is retained in the adapter body with a 1/4" x 1" dowel pin: the square shank is machined onto the end of a short section of 5/8" OD steel rod, which fits loosely (but closely) within the 5/8" ID shaft through the center of the crank. By machining a similar such feature onto the end of a similar section of rod, drilling an appropriate cross hole, & replacing the square shank, any number of drive mechanisms could be supported.