71
edits
Changes
Jump to navigation
Jump to search
Line 59:
Line 59: − + + − +
→Training Checklist
** Drilling
** Drilling
** Feeds and Speeds
** Feeds and Speeds
** Use Mach3 Arcs Inch Post
** Use "Mach2/3 Arcs (inch) (*.txt)" post processor when saving the toolpaths
* Transfer GCode to Mach3
* Transfer GCode to Mach3
** View toolpath
** View toolpath
** You can jog around while the toolpath is showing to see it it is going to cut where you thought it would.
** Regen Toolpath (after jogging)
** Regen Toolpath (after jogging)
** Checking clamps
** Checking clamps
** Feedrate offset
** Feedrate offset. This can be used to slow down a job. Use might want to start below 100% to verify the machine can handle the feedrate you chose.
* Running Job
* Running Job