Changes

|contact = CNC Area Host

|contact = CNC Area Host

|value = $6000

|value = $6000

|image = IMG_4045.JPG

|image = Cncplasma.jpg

}}

}}

== Status ==

== Status ==

Working. Stay tuned for an announcement about authorizations.

Working.

== Authorization ==

== Authorization ==

* Extend air line to under table to create a manifold for table mounted air consumers

* Extend air line to under table to create a manifold for table mounted air consumers

* Run large conduit for 220 outlet for the plasma cutter

* <s>Run large conduit for 220 outlet for the plasma cutter</s>

* Run small conduit for data/estop between the table and the PC

* Run small conduit for data/estop between the table and the PC

* Run black pipe for connecting the table to the bladder (old compressor tank)

* Run black pipe for connecting the table to the bladder (old compressor tank)

* Water line from north side of the shop, with input into the old compressor tank

* Water line from north side of the shop, with input into the old compressor tank

* Air lines to the compressor tank (one vent on from the compressor)

* <s>Air lines to the compressor tank (one vent on from the compressor)</s>

* Run ethernet line to PC so its not on wifi any more

* <s>Run ethernet line to PC so its not on wifi any more</s> - ''WiFi for network access is fine''

* Z axis limit switches

* Z axis limit switches

=== Fine Cut ===

=== Fine Cut ===

'''NOTE''': These parts are for a t30 unshielded torch, they are compatiable with the T45m when it is run at a setting lower than 30A and cutting materials thinner than 3/16". Ohmic sensing will not work with these parts installed.

'''NOTE''': These parts are for a t30 unshielded torch, they are compatiable with the T45m when it is run at a setting lower than 30A and cutting materials thinner than 3/16". Ohmic sensing will not work with these parts installed.

|Ron Olson

|Ron Olson

|01/29/19

|01/29/19

|-

|-

|}

|}