Line 9: |
Line 9: |
| |where = Hot metals | | |where = Hot metals |
| |doesitwork = yes | | |doesitwork = yes |
− | |contact = CNC Area Host | + | |contact = hotmetals at pumpingstationone.org |
| |value = $6000 | | |value = $6000 |
− | |image = IMG_4045.JPG | + | |image = Cncplasma.jpg |
| }} | | }} |
| | | |
| == Status == | | == Status == |
| | | |
− | Working. Stay tuned for an announcement about authorizations. | + | Working. |
| | | |
| == Authorization == | | == Authorization == |
Line 189: |
Line 189: |
| | | |
| * Unknown at this time | | * Unknown at this time |
| + | |
| + | ==== Error: "Probe ignore, activated at call for probe" ==== |
| + | |
| + | '''Tends to happen when attempting to reignite torch after first cut''' |
| + | |
| + | Causes: |
| + | |
| + | *THCv set to high, e.g. cutting 1/4" steel @45A recommended THCv is 115, lower to 114 or until the torch ignites successfully |
| | | |
| == Sheet Cam == | | == Sheet Cam == |
Line 240: |
Line 248: |
| | | |
| * Extend air line to under table to create a manifold for table mounted air consumers | | * Extend air line to under table to create a manifold for table mounted air consumers |
− | * Run large conduit for 220 outlet for the plasma cutter | + | * <s>Run large conduit for 220 outlet for the plasma cutter</s> |
| * Run small conduit for data/estop between the table and the PC | | * Run small conduit for data/estop between the table and the PC |
| * Run black pipe for connecting the table to the bladder (old compressor tank) | | * Run black pipe for connecting the table to the bladder (old compressor tank) |
| * Water line from north side of the shop, with input into the old compressor tank | | * Water line from north side of the shop, with input into the old compressor tank |
− | * Air lines to the compressor tank (one vent on from the compressor) | + | * <s>Air lines to the compressor tank (one vent on from the compressor)</s> |
− | * Run ethernet line to PC so its not on wifi any more | + | * <s>Run ethernet line to PC so its not on wifi any more</s> - ''WiFi for network access is fine'' |
| * Z axis limit switches | | * Z axis limit switches |
| | | |
Line 1,198: |
Line 1,206: |
| |Ron Olson | | |Ron Olson |
| |01/29/19 | | |01/29/19 |
| + | |- |
| + | |Greg Bell |
| + | |Ron Olson |
| + | |03/23/19 |
| |- | | |- |
| |} | | |} |