2
edits
Changes
Jump to navigation
Jump to search
mLine 72:
Line 72: + +
Creality Ender 3 A 3D Printer (view source)
Revision as of 19:05, 30 August 2020
, 19:05, 30 August 2020no edit summary
3(b)1. Open a web browser connected to a computer/device on the PS1 network & enter 10.100.1.203 in the IP address field.
3(b)1. Open a web browser connected to a computer/device on the PS1 network & enter 10.100.1.203 in the IP address field.
Note: If printer has been turned off, you may need to first select "Connect" under the left side Connection tab if the printer has been turned off. '''All settings to connect are retained and should not be modified.'''
Note: If printer has been turned off, you may need to first select "Connect" under the left side Connection tab if the printer has been turned off. '''All settings to connect are retained and should not be modified.'''
If control panel screen is off, click the "Lightning Bolt" immediately above the "GCode Viewer" tab.
This is the PSU toggle. The control panel should now be on.
3(b)2. Warm up the printer (if you haven't already) using the controls on the Temperature tab -- enter a temperature in Celsius and click "Set"
3(b)2. Warm up the printer (if you haven't already) using the controls on the Temperature tab -- enter a temperature in Celsius and click "Set"