483
edits
Changes
From Pumping Station One
Epilog 30w Mini 24 Laser Engraver (view source)
Revision as of 19:55, 7 December 2014
, 19:55, 7 December 2014→Cylinder Attachment
'''NB: Always return the machine back to the default configuration with a cutting bed after use.'''
'''NB: Always return the machine back to the default configuration with a cutting bed after use.'''
=== Installing Attachment ===
# Turn machine on
# Disable X/Y
# Open front cover
# Lower bed almost to the bottom of the machine while still allowing the catch tray to be removed
# '''Turn machine off'''
# Flip up rulers and remove cutting bed
# Remove slide out catch tray
# Install the attachment locating it in the 3 holes in the bottom of the bed '''DO NOT CONNECT PLUG YET'''
# Make sure the Y axis will clear the top of the attachment, if it will not turn the machine on and lower the bed further making sure to turn it off afterwards
# Connect the attachment cable to the connector in the back of the bed
# Turn the machine on - the machine will zero home over the top of the attachment
Reverse steps to uninstall.
=== Usage notes ===
* '''DO NOT USE AUTO FOCUS'''
* 0,0 is '''TOP LEFT'''
* Y axis is wrapped around the piece
* Set Y size to circumference of piece - measure with soft tape or string/ribbon/etc
* Make sure to set print size in driver to same as art board in illustrator
== Known issues ==
== Known issues ==
