388
edits
Changes
Jump to navigation
Jump to search
Line 20:
Line 20: − + − + − + + + +
Epilog 30w Mini 24 Laser Engraver (view source)
Revision as of 23:48, 29 April 2015
, 23:48, 29 April 2015→Top Eight: adding a few big ones
* As of 3/24/2014, parts needed have been identified and are ordered, were under warranty, should arrive by 3/26/2015, and are expected to be installed that evening.
* As of 3/24/2014, parts needed have been identified and are ordered, were under warranty, should arrive by 3/26/2015, and are expected to be installed that evening.
== Top Five ==
== Top Eight ==
* Don't use the autofocus, because it could burn out a motor.
* Don't use the autofocus, because it could burn out a motor.
* Don't cut materials that will ignite or emit dangerous fumes. See section below.
* Don't cut materials that will ignite or emit dangerous fumes (any chlorinated plastic like PVC, for example). See section below.
* Always use the exhaust fans and use the air assist on vector cuts.
* Always use the exhaust fan/always use the air assist on vector cuts.
* You must stay with the job; don't walk away. Things could catch on fire, that would suck.
* You must stay with the job; don't walk away. Things could catch on fire, that would suck.
* Sometimes it's a pain to get the right driver working. http://www.thinkgeek.com/product/11c3/
* Sometimes it's a pain to get the right driver working. http://www.thinkgeek.com/product/11c3/
* Do not attempt to service the machine yourself unless you've cleared it with Elizabeth
* Do not touch any settings in the Config menu on the machine itself
* Do not touch any settings in the Maint menu on the machine itself '''''except''''' you may use Maint/1/Return Home to reset the cutting head to the machine's default origin (.015" inside the top left corner as of 4/28/15)
== General Info ==
== General Info ==