388
edits
Changes
Jump to navigation
Jump to search
Line 47:
Line 47: − + + + + + + + − See main article, [[Epilog techniques]].+ − == Ventilation ==+ − '''Always''' turn on the exhaust fan using the switch located in the silver box to the left of the machine.+ Line 105:
Line 111: − == Air assist == − Air assist is used for vector cutting to have nice traces and avoid your material to burn. However some people like to have it disabled for raster jobs. The best is to use the pressure regulator on the left of the machine to put it on/off. Don't forget to put it off when you've finished and you don't need it while doing your settings, that's just making our air compressor work too much. The pressure regulator has no adjustable settings. It is either on or off. − If you hear a hiss behind the machine while it is cutting, it means that the valve is closed and that ''Air assist will not work'''… You have to stop the job and then: − * Hit '''config (2)''' − * Left key until "Air assist vector" put On with '''Up''' key (You shouldn't have to put Off here as you just have to put the compressor off if you really need that) − * Left key until "Air assist raster" put On with '''Up''' key. − You should not have to touch these settings, especially because it confuses the users and it can make them destroy their material or cause fire. Default settings should be On and On for both.+ − Check the regulator for accumulated water from time to time. Place a container (and maybe some paper towels) under the regulator and vent accumulated water from the bottom using the small petcock. If too much water accumulates in the regulator, it may flow through the air hose and into the machine, spraying onto the bed/material.+
Epilog 30w Mini 24 Laser Engraver (view source)
Revision as of 23:55, 29 April 2015
, 23:55, 29 April 2015Naa, nobody needs to touching firmware settings. The default is on and should stay that way.
Experiment with settings to find the lowest possible power and highest possible speed to get clean vector cuts. The new optics and tube (as of December 2014) can cut many organic materials with a minimum of charring.
Experiment with settings to find the lowest possible power and highest possible speed to get clean vector cuts. The new optics and tube (as of December 2014) can cut many organic materials with a minimum of charring.
== Strategies and techniques ==
== Ventilation ==
'''Always''' turn on the exhaust fan using the switch located in the silver box to the left of the machine.
== Air assist ==
Turn on the air assist by turning the silver knob on the regulator located on the red bracket attached to the left of the machine. The pressure regulator has no adjustable settings. It is either on or off.
Air assist is used for vector cutting to have nice traces and avoid your material to burn. However some people like to have it disabled for raster jobs.
Turn air assist off when you've finished and you don't need it while doing your settings.
Check the regulator for accumulated water from time to time. Place a container (and maybe some paper towels) under the regulator and vent accumulated water from the bottom using the small petcock. If too much water accumulates in the regulator, it may flow through the air hose and into the machine, spraying onto the bed/material.
== '''NEVER CUT THESE MATERIALS''' ==
== '''NEVER CUT THESE MATERIALS''' ==
* [http://www.rubberstampmaterials.com/laserengravablerubberandpolymer.aspx Laser-engravable rubber and polymer, for stamps]
* [http://www.rubberstampmaterials.com/laserengravablerubberandpolymer.aspx Laser-engravable rubber and polymer, for stamps]
== Strategies and techniques ==
See main article, [[Epilog techniques]].
== General references ==
== General references ==