131
edits
Changes
Jump to navigation
Jump to search
Line 92:
Line 92: − + − + + +
Epilog 30w Mini 24 Laser Engraver (view source)
Revision as of 18:11, 8 October 2016
, 18:11, 8 October 2016→Cleanup - changed to finishing up, and added a bit about leaving fans running.
Check the regulator for accumulated water from time to time. Place a container (and maybe some paper towels) under the regulator and vent accumulated water from the bottom using the small petcock. If too much water accumulates in the regulator, it may flow through the air hose and into the machine, spraying onto the bed/material.
Check the regulator for accumulated water from time to time. Place a container (and maybe some paper towels) under the regulator and vent accumulated water from the bottom using the small petcock. If too much water accumulates in the regulator, it may flow through the air hose and into the machine, spraying onto the bed/material.
== Cleanup ==
== Finishing up ==
Please leave the machine cleaner than you found it by emptying the crumb tray below the cutting table, picking up cutouts, and vacuuming up any acrylic dust you made.
Leave the machine running as you pack up - the laser tube is air cooled by fans. Leaving the fans running after your job is done will help cool it off and make it last longer. The last thing to do before you walk away from the machine is to turn it off.
Please leave the machine and the surrounding area cleaner than you found it by emptying the crumb tray below the cutting table, picking up cutouts, and vacuuming up any acrylic dust you made. While you're waiting on the laser is a good time to grab a shop vac and clean the vicinity.
== Troubleshooting ==
== Troubleshooting ==