Difference between revisions of "Evenheat 810 Kiln"
Jump to navigation
Jump to search
(Update links) |
(Usability update) |
||
| Line 1: | Line 1: | ||
| − | {{Template:EquipmentPage |owner=PS:One |model=Evenheat 810 |serial=38008 |arrived=2010 |doesitwork= | + | {{Template:EquipmentPage |owner=PS:One |model=Evenheat 810 |serial=38008 |arrived=2010 |doesitwork=Works |contact=Eric Stein |where=? |certification=yes |hackable=no |value=$865}}<br> |
| − | On 1/28/2013 this was tested to at least power up and create heat. | + | ==History== |
| + | On 1/28/2013 this was tested to at least power up and create heat. <br> | ||
| + | 3/3/2014. Inspect and test all mechanical and electrical components. <br> | ||
| + | Remove upper switch, disassemble, clean contacts, reassemble and reinstall. <br> | ||
| + | All components appear to works as intended. | ||
| + | |||
| + | ==Heating Profile== | ||
| + | On 3/3/2014 I ran the kiln using a PID temperature controller set to 2200f. <br> | ||
| + | Room temp to 500f. 7 min. <br> | ||
| + | Room temp to 1000f. 17 min. <br> | ||
| + | Room temp to 1500f. 40 min. <br> | ||
| + | Room temp to 2000f. 95 min. | ||
==Important Documents== | ==Important Documents== | ||
| Line 13: | Line 24: | ||
[[Category:Craft]] | [[Category:Craft]] | ||
[[Category:Pottery]] | [[Category:Pottery]] | ||
| + | [[Category:Photographs Needed]] | ||
Revision as of 00:23, 4 March 2014
 | This tool is currently broken, please contact the area host for more information. |
| Owner/Loaner | PS:One |
|---|---|
| Serial Number | 38008 |
| Make/Model | Evenheat 810 |
| Arrival Date | 2010 |
| Usability | Works |
| Contact | Eric Stein |
| Where | ? |
| Authorization Needed | yes |
| Hackable | no |
| Estimated Value | $865 |
| Host Area | {{{hostarea}}} |
History
On 1/28/2013 this was tested to at least power up and create heat.
3/3/2014. Inspect and test all mechanical and electrical components.
Remove upper switch, disassemble, clean contacts, reassemble and reinstall.
All components appear to works as intended.
Heating Profile
On 3/3/2014 I ran the kiln using a PID temperature controller set to 2200f.
Room temp to 500f. 7 min.
Room temp to 1000f. 17 min.
Room temp to 1500f. 40 min.
Room temp to 2000f. 95 min.